Metal Siding Panel Base Details

Standard details for metal roofing siding post frame and residential structures distributed by.

Metal siding panel base details.

Instead use a protective base of con crete treated wood or similar material and stop the siding sheets 6 above grade. Fe 66 metal siding wall panel cad standard details the fe 66 is a 12 wide wall siding panel recessed every six inches to provide a shadow effect. 080108 crl 07 4213 1 metal wall panels section 07 4213 metal wall panels use this section when specifying c r. Planning 4 siding styles 5 accessories 6 tools required 7 equipment 8 material estimating 9 nomenclature insulation 10 energy saving getting started11 preparation 12 furring and insulation techniques 14 base chalk line 15 inside corner posts 16 outside corner posts trim 17 starter strip 18 window and door trim 19 window and door trim gable end trim installation 20 cutting procedures.

Non recessed sheeting exposes the ribbing at the base of the wall panels around the perimeter of the steel building. Our metal siding panels can be used for new construction or to retrofit existing buildings. Laurence ews series 100 standard wet seal wall panel system. Instead provide a protective base of concrete masonry treated wood.

Way to the ground. On the pbr profile installers should. Our architectural metal wall panels include single skin insulated exposed fastener concealed fastener and interior wall liners and most can be installed both vertically and horizontally providing additional flexibility in design. The details in this manual are for through fastened panels only.

If you do not opt for base trim it is recommended that the concrete foundation is notched to allow for recessed sheeting. The two panels can be used alone or in combination to create interesting highly architectural effects. Fabral s standing seam panels have their own manuals. If liner panel is chosen as an accessory the base condition at lined walls will automatically be added.

Refer to the respective standing seam panel manual for installation instructions and details. Do not run the siding sheets all the way to the ground. Metal panels and any potentially corrosive materials should be pre.